AEC Online
Printable version Bookmark this page Notify a colleague or friend about this page Bookmark and Share

About Ecobulb

Brochures  

Ecobulb

A key reason for electricity utilities selecting the EcobulbŪ™ is its high power factor technical superiority. The high power factor EcobulbŪ™ results in a 50% greater electricity distribution network load reduction (approximately 17VA per bulb) than ordinary CFL's. This increased reduction is worth approximately $16 per EcobulbŪ™ of deferred new electricity distribution network capital investment for the utilities.

Large numbers of ordinary CFL's are also detrimental to electricity utility networks, as they cause electrical interference on their networks. This requires expensive electronic correction by the utilities. The high power factor EcobulbŪ™ does not create this electrical interference. Consequently, $6 of network correction per EcobulbŪ™ is avoided relative to installing a CFL.

A large Utility in Sydney, Australia recently ordered 180,000 EcobulbsŪ™, despite the higher price than low power factor CFL's they were pursuing This was because the utility was concerned about the impact of high numbers of CFL's on performance of the peak load shedding control systems.

An electricity utility network that replaces one million incandescent bulbs on at peak network times with EcobulbsŪ™ will save $16 million more ($12 plus $4 per bulb times 1 million EcobulbsŪ™) than if these bulbs were replaced with ordinary CFL's. Consequently it is extremely cost effective for electricity utilities to implement EcobulbŪ™ projects, rather than let the market replace incandescent bulbs with ordinary CFL's.

Other light bulb manufacturers have attempted to develop high power factor CFL's. However, these bulbs are typically larger, with lower light output and reduced lifetimes. As they are more expensive to manufacture with no perceived consumer benefit, these developments have invariably ceased. It is likely that they will eventually produce viable high power factor CFL's to compete against the EcobulbŪ™. However, the EcobulbŪ™ then has a 15 month first mover advantage. This is because it takes 15 months to complete the CFL lifetime testing required by the electricity utilities before they would purchase these bulbs.

Brochures

Brochures
Preview Description Format Size Open
Ecobulb Leaflet
PDF 590 kB Open
Ecobulb Specification Sheet
PDF 307 kB Open

*Request for Information
 
(Please check companies and/or products above. Not to be used to promote your products or services.)
 
*Name:    
*Email:    
Company:    
*Company type:    
*Phone:    
*Address:    
*Request:    
    (* = Mandatory field) 
     


16050 - Basic Electrical Materials and Methods

Categories: Ecobulb, bulb, electrical, energy saving, green, network load reduction.



Skyscraper Banner