Comprehensive Remote Access...
The TO-PASS® Web connector from WAGO enables simple and comprehensive integration of fault detectors in I&C systems.
Telecontrol and monitoring of remote sites or mobile devices is no problem at all for TO-PASS®. Using the Web connector, TO-PASS® telecontrol modules can now be integrated to an even greater extent into the control center.
The heart of this Web connector is a special function block for the CoDeSys development topology. This function block registers the HTTP queries from the telecontrol modules, saves the process image in a global variable list and transmits a corresponding acknowledgement. The received data can then be processed by the WAGO-I/O-SYSTEM as needed.
Economical, bidirectional transmission using the Web connector is also used by network service providers to comply with the renewable energy act: The power reduction required by this act based on IEC 60870-5-104 is achieved by technical means by private power producers using TO-PASS®.
TO-PASS® Telecontrol Technology
From a fault message via process and position data acquisition up to a fully functional PLC: The WAGO TO-PASS® family of products is made up of modular and perfectly matched telecontrol components, which enable independent monitoring of remote objects – at any time and anywhere in the world.
TO-PASS® Compact, Mobile and Outdoor communicate over wireless links via the GSM mobile communications network and therefore do not rely on data lines or radio links. Data can be sent to a freely selectable target address, for example to the TO-PASS® Web portal.
Even greater integration into I&C systems: The "Web Connector" function block integrates isolated remote sites or mobile devices directly into the CoDeSys development topology.